WEBES v5.4 - Error Code: E2E

[geraldo gassen]

Hi all,
my customer installed the webes v5.4 and receives the message below to each 8h.

Version: 1.0
Error Code: E2E
Description: Webes HeartBeat test failed to log event. Webes may not be in running state.

I try the workaround:
DOS>net stop desta_service
DOS>net stop wccproxy
DOS>net start wccproxy
DOS>net start desta_service

Doesn't work...

is anybody known this problem this solved in the webes v 5.5?

Many thanks in advance.

[avizen9]

Hello
Please go through below thread having similar issue, may it help you,

[broken link removed on <4/4/2017> by Mod] 

[geraldo gassen]

Hi avizen9,
My version is 5.4 and the article version is 5.1 and 5.2.
In v 5.4 this problem should already be resolved.

[Olivier Masse]

These nasty E2E messages have been going on and on for ages, across multiple versions of WEBES. I've seen them a few times with WEBES 5.4 but it has been quite for a while for me now.

5.5 just got released, there's no mention of exactly what it fixes in the release notes but you might give it a try.

Good luck

[Veli Körkkö]

You can always stop the messages coming. Just do

DESTA WHC OFF

but this will disable the webes internal healthcheck completely.

_veli

[Sebastian.Koehler]

You should not disable the health check cause the director might fail and you would not notice.

E2Es will occur unless log notification is enabled. Log notification can be enabled from either the SEA Web User Interface or else from the command line using the command "wsea log prob on".

Regards,
Sebastian

[JKytsi]

Well... still getting the E2E errors. WEBES 5.5 patch1

[geraldo gassen]

upgrade the version.