Integrity Servers
1748145 Members
3623 Online
108758 Solutions
New Discussion юеВ

Re: Adding a new cell

 
Roro_2
Regular Advisor

Adding a new cell

Hello,
our customer needs to add a second CELL board to the rx7620 server working under HPUX 11i 11 23.

1-The working cell board has 4 cpu modules 1600 MHz .
SFW F/W is 3.096
PDHC F/W is 3.027
MICE rev. is 1.0

2-The new cell board has 4 cpu modules 1600 MHz.
SFW F/W is 3.096
PDHC F/W is 3.031
MICE rev. is 1.0

Please advise if we can add and configure the second cell ;
Should we upgrade the FW and how.

Thanks and Regards

Roger

5 REPLIES 5
likid0
Honored Contributor

Re: Adding a new cell

Hy,

If you are going to use it, for the same npar the firmware has to be the same, if you are going to create a new npar, it's recommended to have the same firmware but not a must.


Updating FW is a service that HP should do.


You normally need to leave the cell you are going to update on BIB, and then update the firmware from the mp.

if your system is critical, and you don't have downtime you can downgrage the firmware version from your new cell(to the same on the old cell, add the new cell to the npar, and then you only have the downtime of a reboot for reconfig.
Windows?, no thanks
Roro_2
Regular Advisor

Re: Adding a new cell

Hello,

Please i want to know how can i update the FW of either cell.

Thanks and Regards

Roger
Torsten.
Acclaimed Contributor

Re: Adding a new cell

Firmware is stored on www.hp.com -> software and drivers , but CAUTION - if you don't follow the instructions strictly you may seriously damage your system!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Jozef_Novak
Respected Contributor

Re: Adding a new cell

I will only add that cell firmware upgrade is a task for qualified HP service personnel.

J.
Jorge Pons
Trusted Contributor

Re: Adding a new cell

Hi

If you want to update fw, you must download the fw necessary and generate a CD. You boot from it update fw, the process is automatic.

Regards