BL860i2 and Fibre Disks

[Mark Tulsa]

Created LUN on P2000G3 and see wwn of array controller with lun in the efi devices. Was told to install VMS 8.4 on internal disk, patch and then use FC disk for boot device. Have done so but VMS does not see FC disk. Using the vms_show.efi I see devices from efi level but they are all DGA0 any Ideas?

[Torsten.]

VMS is not my subject, my I assume you need to set the server profile to "OpenVMS" while configuring the host entries on the array (use the CLI!).

[Torsten.]

See my thread here:

http://h30499.www3.hp.com/t5/Disk-Array/P2000-host-profile/m-p/4777543#M37507

[Mark Tulsa]

Thank You for your help I found the flag in the config setup and can now see the disks when I issue an IO auto from VMS.