Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

BL860i2 and Fibre Disks

 
Mark Tulsa
Occasional Visitor

BL860i2 and Fibre Disks

Created LUN on P2000G3 and see wwn of array controller with lun in the efi devices. Was told to install VMS 8.4 on internal disk, patch and then use FC disk for boot device. Have done so but VMS does not see FC disk. Using the vms_show.efi I see devices from efi level but they are all DGA0 any Ideas?
3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: BL860i2 and Fibre Disks

VMS is not my subject, my I assume you need to set the server profile to "OpenVMS" while configuring the host entries on the array (use the CLI!).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: BL860i2 and Fibre Disks

See my thread here:

http://h30499.www3.hp.com/t5/Disk-Array/P2000-host-profile/m-p/4777543#M37507


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Highlighted
Mark Tulsa
Occasional Visitor

Re: BL860i2 and Fibre Disks

Thank You for your help I found the flag in the config setup and can now see the disks when I issue an IO auto from VMS.