Can't Upgrade Management Processor Firmware to current release

[James Simmons_3]

I'm trying to update my MP card firmware to version E.03.13 on an rx5670.

My MP card currently has version E.02.10 installed.

In order to upgrade to any version newer than E.02.26, you must (according to HP) upgrade to E.02.26 first.

Unfortunately I cannot locate a downloadable E.02.26 firmware installation on the patch and firmware download site.

Any way around this issue?
Thanks.

[kris rombauts · Accepted solution]

James,

try this link, it has all MP F/W rev's.
Just go to www.hp.com choose drivers and enter rx5670 and you get here:

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?locale=en_US&pnameOID=88844&taskId=135&prodTypeId=15351&prodSeriesId=447334&submit.y=3&submit.x=8〈=en&cc=us&swEnvOID=54


HTH

Kris

[James Simmons_3]

Oops... Sorry. I finally found the download for E.02.26. It showed up in "download drivers and software" section of support site... Not in the firmware downloads where all the other versions were listed.

I think I'm back on track now.

[James Simmons_3]

Thanks Kris. I found it just about the same time you posted your message.

I gave you points anyway!!!

[KVK]

Hi James,

Kris has given the correct location still if you face probelm just reply to the forum,

Find the recommanded details as given below . i fetched this information from MP firmware release notes

********************************************************************************
System Requirements and Dependencies:
********************************************************************************

CAUTIONS: Depending upon the currently installed MP firmware, interim upgrades
to previous revisions of MP firmware may be required in order to upgrade to
iLO MP firmware revision E.03.13. Please follow the upgrade requirements below:

1 - If the currently installed MP firmware is older than E.02.10 then
updating to MP firmware revision E.02.26 requires updating to E.02.10
first.
2 - Upgrades to MP firmware revision E.02.29 will require updating to MP
firmware revision E.02.26 first.
3 - MP firmware must be at or upgraded to revision E.02.29 prior to upgrading
to iLO MP revision E.03.13.

[James Simmons_3]

Successfully upgraded to 02.26 and then to 03.13.

Thanks for all the help.

Jim