EFI Boot Manager - it does not work

[rx2620 itanium 64 bits]

when igniting the equipment, I obtain the following message.


/////////////////////////////////////////////
Skipping thread control, BYPASS_THREAD_CONTROL_BIT Set!
Skipping thread control, BYPASS_THREAD_CONTROL_BIT Set!
0 0 0x00001D 0x001F020200000000 CPU0 starting cpu config
0 1 0x00001D 0x001F020200000001 CPU1 starting cpu config
0 0 0x00000E 0x0000000000030000 CPU0 at monarch selection
0 1 0x00000E 0x0001000000030000 CPU1 at monarch selection
0 1 0x00005D 0x0000000000000002 CPU1 at rendezvous
1 0 0x00000C 0x0000000000000000 CPU0 is the monarch
1 0 0x000261 0x0000000000000000 CPU0 present
1 1 0x000261 0x000000000000
0 0 0x0015B2 0x0000000002325593 boot time event
0 0 0x000008 0x0000000000000000 starting cell config
0 0 0x000056 0x0000000000000000 scratch ram test
0 0 0x00024B 0x0000000000000000 early platform check
cpu family 0x1f active!
0 0 0x00004A 0x0000000000000000 nvram not initialized
0 0 0x00004B 0x0000000000000000 nvram test
5£²þ²þ²þ´³²þ· · ·»·v76²þ2'óóH

/////////////////////////////////////////


in it completes line, single I obtain characters ASCII and el EFI Boot Manager - it does not work

as I can restore the EFI ???

[melvyn burnard]

posted in completely the wrong forum!
Moved to more appropriate forum

[Robert Gezelter]

rx2620 itanium 64 bits,

Did you change any of the parameters from the factory defaults?

- Bob Gezelter, http://www.rlgsc.com

[rx2620 itanium 64 bits]

yes, I change the console by default

[Robert Gezelter]

Can you telnet to each of the consoles using the numeric IP addresses?

- Bob Gezelter, http://www.rlgsc.com

[rx2620 itanium 64 bits]

EFI does not work

[rx2620 itanium 64 bits]

first the operating system raises EFI later