Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
Showing results for 
Search instead for 
Did you mean: 

EFI Shell

Jonathan Grymes
Frequent Advisor

EFI Shell

Booting server to get EFI Shell. To determine sasflash version and display information about about 1068 and 1068E cards on the system. Every command I type returns invalid parameter.

System is HP-UX 11.23 (rx2660)


At the Shell prompt:



Invalid parameter

shell>sasflash -listall

Invalid parameter



P.S. this thread has been moved From HP-UX > System Administration to Servers > Integrity. - Hp Forum moderator

Acclaimed Contributor

Re: EFI Shell

These commands are not built-in.

Use sasmgr from hp-ux, example:

$ sasmgr get_info -D /dev/sasd0
Driver Name : sasd
Bundle Version : B.11.31.01
Product Number : 399490-001
Hardware Path : 0/4/1/0
Health of HBA : ONLINE
PCI Vendor ID : 0x1000
PCI Device ID : 0x0054
PCI Subsystem Vendor ID : 0x3228
PCI Subsystem ID : 0x103c
PCI Revision ID : 0x0000
Max. PHYs supported : 8
Max. IO size : 1048576

***** HBA Specific information *****
HBA state : READY
Driver firmware dump available : NO
Driver firmware dump timestamp : N/A
Firmware Revision :

Hope this helps!

There are only 10 types of people in the world -
those who understand binary, and those who don't.

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: EFI Shell

Sasflash is a utility that comes with the sas fw download. So it is not native to the efi shell. You can download (on mobile no link) put on a usb to execute at the efi.

You will have to change to the partition of usb disk. Usually it is fs0:
I work for HPE.

Re: EFI Shell

Hi ,


Please check this URL fro more infromation on SASflash  and firmware driver:


 SAS HBA EFI driver/firmware


sasflash.efi  -   EFI  utility to update  EFI  driver  and HBA firmware on Serial Attached  SCSI  adaptor  based  on  LSI  1068





I work for HPE

If you feel this solution was helpful please click the KUDOS! thumb below!

Re: EFI Shell

thansk for share~