HP RX2660 iLO reset

[HP-UX_Newb]

How do I reset the iLO (MP) settings to the default settings? I'm not sure what happened but I used to connect by IP via hyperterm and now the IP address has been changed and no one remembers it. Is there anyway I can reset the iLO to default? And does anyone know the the default IP is once you change it back to the default settings?

[Sunil Kumar H G]

Hi Timothy,

Below link might be helpful:

http://g4u0420c.houston.hp.com/en/5991-6006/ch02s03.html

Regards,
Sunil

[HP-UX_Newb]

Thanks, Sunil Kumar H G!

I noticed it's for the HP 9000, but hopefully it's the same for the RX2660 model. All I need now is to look for that reset "button"!

[Sunil Kumar H G]

Hi Timothy,

You are Welcome!

Below link might help!

http://docs.hp.com/en/AB419-9005A/AB419-9005A.pdf

Regards,
Sunil

[Vijaykumar_1]

This is how you reset to the default settings on rx2660.

MP>DC


DC

==== MP Help: General Configuration ===========================================

DC : Default Configuration- reset all parameters

Command access level: MP Configuration access.

This command sets all MP parameters back to their default values.

To restore specific configurations to their defaults use the following commands:
MP IP configuration : LC -all DEFAULT
Remote Access Configuration : SA -all DEFAULT
Command Interface configuration : IT -all DEFAULT
MP Security configuration : SO -opt DEFAULT
MP Session configuration : IT -all DEFAULT
MP User configuration : UC -all DEFAULT
MP LDAP directory configuration : LDAP -all DEFAULT
SNMP Configuration : SNMP -all DEFAULT

Command line usage:
DC [ -all default [ -nc ] ]

[HP-UX_Newb]

Thanks, Vijaykumar!

But my problem is getting into the MP. With Sunil Kumar H G helps, I'm looking for the reset "button". I think it's next to the UID light, to the left of it if you are looking at it from behind. I'm waiting for off hours before I push the button. I don't want to take it down while people are still using.

Thanks anyway!

[HP-UX_Newb]

You know what guys, stupid me! I totally forgot that I can just use the console serial port to get in and re-configure everything.

I really appreciate you guys responding to this anyway!

Cheers!

[HP-UX_Newb]

I don't need to use the iLO LAN port to get into the MP. I forgot that I can use the console serial port to get into the MP.