Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

How to active one PDHC in one RX7640

Carme Torca
Super Advisor

How to active one PDHC in one RX7640

Hi,

 

I have one rx7640 with this configuracion:

 

CM> sysrev

...


FIRMWARE:

Core IO
  MP-0          :  B.004.002.003
  ED-0          :    002.011.000
  MP-1          :  B.004.002.003
  ED-1          :    002.011.000

Cell 0
  PDHC          :  B.023.003.033 - Active
  PDHC          :  B.023.003.040 - Pending
  IPF_FW        :    007.044.000
  IPF_FW        :    009.066.000 - Active
Cell 1
  PDHC          :  B.023.003.033 - Active
  PDHC          :  B.023.003.040 - Pending
  IPF_FW        :    009.066.000 - Active
  IPF_FW        :    007.048.000

 

How could I active the PDHC B.023.003.040, that is Pending?

 

Thanks a lot of!

Carmen.

 

 

P.S. This thread has been moved from HP-UX > System Administration to Servers > Integrity. - Hp Forum Moderator

Users are not too bad ;-)
2 REPLIES
Torsten.
Acclaimed Contributor

Re: How to active one PDHC in one RX7640

This is a bit strange, because the active version is bundle 3.1, all other components have bundle 4.2 installed.

 

Maybe someone forgot a reset or power cycle during the update?

 

You should power cycle the complete system.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Highlighted
Carme Torca
Super Advisor

Re: How to active one PDHC in one RX7640

 

HI,

Yes. We shutdown all the lpars, put OFF the cells and start all again...

Users are not too bad ;-)