- Community Home
- >
- Servers and Operating Systems
- >
- Integrity Servers
- >
- Re: Integrity installation
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2007 01:56 AM
тАО01-31-2007 01:56 AM
Integrity installation
I install HP-UX 11iv2 on rx1620 with MP card, but i can't get output via MP card (using telnet into MP, serial console on MP), only on serial console of the server. Options in EFI Boot menu are set up "by the book".
I do firmware upgrade of hole system.
Nothing help.
What I'm missing?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2007 02:02 AM
тАО01-31-2007 02:02 AM
Re: Integrity installation
What version of the firmware are you using?
Disconnect the serial console and try again?
You may have a hardware problem with the MP card.
SEP
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2007 02:16 AM
тАО01-31-2007 02:16 AM
Re: Integrity installation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2007 06:37 PM
тАО01-31-2007 06:37 PM
Re: Integrity installation
The problem was that you can select in EFI default user interface between legacy and enhanced.
In enhanced user interface you can set up primary console (even if you select the right one in legacy user interface).
That situation wasn't documented by the HP as far I know.
Thanks anyway!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2007 06:39 PM
тАО01-31-2007 06:39 PM