HPE Community
Integrity Servers
1753818 Members
8750 Online
108805 Solutions
New Discussion юеВ

MP Time on an rx2600

 
Ray Carlson
Frequent Advisor

тАО11-03-2002 02:19 PM

тАО11-03-2002 02:19 PM

MP Time on an rx2600

Does anyone know how to set the time that is recorded by the Event log in MP? I have stopped at EFI shell and set date and time there. If I do a reset, that date and time will go for that boot. However, the next boot will change the date and time back to what it was previously, which was 1 day, 4 hours, & 45 minutes earlier than the real time.
Any ideas?
0 Kudos
Reply
2 REPLIES 2
Berlene Herren
Honored Contributor

тАО11-04-2002 08:55 AM

тАО11-04-2002 08:55 AM

Re: MP Time on an rx2600

Hello Ray,

Have you tried booting into hp-ux and setting the time? Does it always go back to 1 day, 4 hours and 45 minutes earlier? I was thinking the battery, but not if it is this consistent.

Berlene
http://www.mindspring.com/~bkherren/dobes/index.htm
0 Kudos
Reply
Ray Carlson
Frequent Advisor

тАО02-12-2003 07:53 AM

тАО02-12-2003 07:53 AM

Re: MP Time on an rx2600

Just for peoples information, the solution was a firmware upgrade. Unfortunately, the firmware upgrade broke the dump ability. However a new patch then fixed the dump problem. It's always fun to be on the front line.
Ray
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.