RX2600 Has no Display

[Torsten.]

If the problem

"RX2600 Has no Display"

is now solved (I think so), you may consider to close this thread.

If needed, open a new thread about the firmware update.

Otherwise this thread is getting confusing because of the lengths...

[MALIK ADEEL IMTIAZ]

Dear Torsten,

I get display only through HYPER TERMINAL not from normal boot. If you want me to close this threat i am closing it.

Thanks
Adeel Imtiaz

[Torsten.]

What is "normal boot"? VGA?

If you want, you need to configure the console settings from the EFI settings menu.

Regarding the firmware - this may be helpful (scroll down to the firmware part):

http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1028277

[Torsten.]

Adjust console settings:

http://docs.hp.com/en/5992-1978/ch04s01.html#cihgcffj

[Desmond Tiong]

Hi Malik,

You can get the display from console but your OS failed to boot up possibly due to the SFW issue as it's too old for the server. You only be able to see the output from CO through the MP console unless your server is bootable. Your current bootup failed at SFW level, not yet to the OS level thus you wont see anything, only the MP menu. Lets try to update the firmware or get the system board replaced

[MALIK ADEEL IMTIAZ]

Dear All

Thank you so very much for your quick support and replies. I have no words to thank you all of you for your very kind support specially Sanjeev and Torsten and all.
I will contact local HP vendor for help.

Regards
Adeel Imtiaz
Netsol Technologies
Lahore Pakistan
adeel.imtiaz@netsolpk.com

[Torsten.]

You are welcome!

Good luck and have fun!

[Sharma Sanjeev]

Thanks IMTIAZ and you are welcome any time

Regards
Sanjeev