RX4640 SNMP trap and community setting on MP

[Jason Lee3]

Hi,

I can't see where I set the SNMP trap destination and community string on the MP on an RX4640. I have set the host OS level SNMP settings no problem but want to provide hardware level trapping. Within "CM" - "ID" - I can set the snmp contact details and server information but that's all. Any ideas?

Thanks for any assistance.

Jason

[Sameer_Nirmal · Accepted solution]

Did you try
MP -> CM -> SNMP

You have to have iLO MP E.03.30 version installed to do SNMP configuration.

Refer this link as well.
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=88837&swItem=ux-41515-1&prodNameId=346361&swEnvOID=54&swLang=13&taskId=135&mode=4&idx=1

[Jason Lee3]

Thanks for the info on the MP FW, that might explain it (We are only running E.03.15).
Is the SNMP config performed at the CM level or via a browser to the MP?

Regards

Jason

[Sameer_Nirmal]

SNMP configuration could be done via

MP -> CM -> SNMP
http://docs.hp.com/en/5971-4289/ch07s02.html

as well as

Web Graphical Interface as mentioned at
http://docs.hp.com/en/5971-4289/ch06s04.html#d0e5332