RX6600 adding two new drives as raid 1

[rjpierson]

HP_UX 11.3, my first two drives are setup as raid 1 mirrors, slots 1 and 2, I ran out of space in /opt from netbackup so I added two new 147gb in slots 3 and 4. SAM sees them as does ioscan.  I missed the installer from HP who set the initial raid up two years ago and I figured it would be the same as  the proliant and offer the controller setup at boot, nope don't see it through ilo during boot.  How and where is the raid setup on the RX6600 for the internal controller ?

Thanks

Rich

[iLuke]

Go to EFI Shell and type command drvcfg -s that should fire up LSI MegaRAID configuration utility :)

[Ajin_1]

HI

May it was SAS HDD using sasmgr commanad to check and configure mirror