cancel
Showing results for 
Search instead for 
Did you mean: 

RX7640 CPU4?

 
Highlighted
Zammann
Occasional Visitor

RX7640 CPU4?

Hello all,  I have an Alert level 3 message indicating CC chip fan failing.

 

Physical Location: Processor fan Cabinet 0 cell 0 CPU 4

 

The diagram on the srever shows CPU 0 to 3 locations

 

My question is, should I be looking at this like a Raid?

where as 0 is 1 and 3 would be CPU4.

 

Thank you for any help.

 

2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: RX7640 CPU4?

Your picture is showing CPU 0 and 2 installed, so it could be the fan in the middle (cell controller).

 

Could you post the exact error message together with a "ps" output from MP (cell0 and cabinet)?

 


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: RX7640 CPU4?

If the event you've seen in the MP FPL shows  CC_FAN_FAIL, then Torsten. is right.
The issue is about the Cell Controller FAN (the one in the middle).
Just launch DE command on MP:CM> and look at the real current status of the CC Fan (you need to select PDHC and then the cell).

 

 

Kind Regards,

 

Graziano Palasciano

___________________________________________________________________


Advanced Solution Engineer

Hewlett-Packard Enterprise