HPE Community
Integrity Servers
1753905 Members
10482 Online
108810 Solutions
New Discussion юеВ

Re: Rx2660 VGA problem

 
SOLVED
Go to solution
Vincent_5
Super Advisor

тАО06-05-2011 10:29 PM

тАО06-05-2011 10:29 PM

Rx2660 VGA problem

Hi guys,
Can anyone advice how to enable the VGA on rx2660 in order to see the graphics mode for hpux. I have connected the rx2660 server on a KVM switch which after changing conconfig to VGA I can c the text screen on my LCD but it does to goes to CDe . can someone advice ?

Regards
Vincent
nothing is better than to know more
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО06-06-2011 12:09 AM

тАО06-06-2011 12:09 AM

Solution

Re: Rx2660 VGA problem

Make sure CDE is installed and try

Check /etc/dt/config/Xservers.
If last line is commented out as follows:

# * Local local@console /usr/bin/X11/X :0

remove '# ' and restart dtlogin:

# /sbin/init.d/dtlogin.rc stop
# /sbin/init.d/dtlogin.rc start




Don't use VGA as console, because you can no longer access it via MP!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
Vincent_5
Super Advisor

тАО06-06-2011 03:29 PM

тАО06-06-2011 03:29 PM

Re: Rx2660 VGA problem

Hi Torsen,
Thanks for the info, I found the problem I think by default CDE env is not install. After installing it work .

Regards
Vincent
nothing is better than to know more
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.