HPE Community
Integrity Servers
1753925 Members
9240 Online
108810 Solutions
New Discussion

Re: Rx6600 MP LIGHT NOT ON

 
shabash
Frequent Advisor

‎09-13-2009 08:30 PM

‎09-13-2009 08:30 PM

Rx6600 MP LIGHT NOT ON

I have tried everything for MY mp lan but unable to see the any connection light on MP port.
With my laptop its working fine and light will blink but on network it wont even show any connection light.
i have check tht cable with my laptop with same ip and gateway,its working fine with my laptop and light keep blinking.

i have change the speed to auto negoitiate and also tested the 10baseT but still not able to see any light on MP port on network with switch.

i have connected other switch cable with this server but still not able to see connection light on this server.

Someone with exprience?????
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎09-14-2009 05:58 AM

‎09-14-2009 05:58 AM

Re: Rx6600 MP LIGHT NOT ON

The MP port (labeled as "MP LAN") has 2 LEDs - upper is yellow (10/100 mode), lower is green = link).

So you don't have the green light?

What does

MP:CM> ls

tell you?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.