Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

SCSI ID configuration for A5838A on HPUX Itanium rx4640

 

SCSI ID configuration for A5838A on HPUX Itanium rx4640

Hello,

I need to change the default (7) SCSI ID to 6 for the SCSI card A5838A. This since the disk connected is a shared disk for a HA cluster.
The server is HPUX Itanium rx4640.

I tried using the EFI as recommended in the Manual. But on using the "drvcfg" command, the Driver and Controller of this card is not listed.

Am I missing something? Do I need to install a specific driver or configuration something else?

Thanks & Regards
Manminder
5 REPLIES 5
Thayanidhi
Honored Contributor

Re: SCSI ID configuration for A5838A on HPUX Itanium rx4640

Hi,

For RP series I use "SCSI init bus slot ID"
command.

For RX, not tried yet.

info io & devtree

are listing the card?

TT



Attitude (not aptitude) determines altitude.

Re: SCSI ID configuration for A5838A on HPUX Itanium rx4640

info io and devtree shows the card, but drvcfg does not show the card information.

Manminder
Thayanidhi
Honored Contributor

Re: SCSI ID configuration for A5838A on HPUX Itanium rx4640

Hi,

I am helpless. Check the following.

1) If you boot normally (without connecting to other host) is this SCSI card is working?

2) If you two systems try to change the other systems SCSI ID.

3) Make sure the card is seated properly!

4) Try to change the slot.

The above may be silly, but give try.

TT
Attitude (not aptitude) determines altitude.
Laurent HOLKA
Occasional Visitor

Re: SCSI ID configuration for A5838A on HPUX Itanium rx4640

Hi,

If you don't see your card with EFI drvcfg command perhaps you have to load first the EFI drivers !

I'm not a HP-UX specialist and I don't use this card on Integrity ! But as Windows specialist when I use a certified Windows card (like Emulex)and I want to configure it in EFI, I have to load the EFI driver first to see it in drvcfg command.

I hope it help,
Laurent.

Re: SCSI ID configuration for A5838A on HPUX Itanium rx4640

After looking around for quite a while on the online manuals etc. found that changing of SCSID for this card in HPUX 11.23 V2 is not suppoprted. ;-(

Manminder