Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

SD32A Cell Error SMG LED is OFF

 

SD32A Cell Error SMG LED is OFF

Hi,

I have problem with one SD32A, a complex of 3 cells presents a cell error during startup, i can not add this cell in the partition because of this error

HW status for Cell 2 in cabinet 0: FAILURE DETECTED
Cell power Status: enabled, good, NON-CRITICAL FAULT, NVRAM battery good
Boot is blocked; PDH shared memory is not-initialized
Cell Attention LED is off, PDH status LEDs: **__
Cell enabled by PDHC
Core cell is INVALID
RIO cable status: RIO IN CABLE NOT CONNECTED
RIO cable connection physical location: cabinet 15, IO bay 3, IO chassis 3

| CPU Modules | |Cell Power Board |
| | | Cell Board |Converter Faults |
|Populated| Faulted | Power Converter Faults | MEM | JAB | IB |
| 0 1 2 3 | 0 1 2 3 |CLK|L2C|LNK|CORE|FSB|48V|0 1 2| 0 1 |0 1 2|
+---------+---------+---+---+---+----+---+---+-----+-----+-----+
| * * * * | * * * * | | | | | | | | | |

| | Side: | A | B |
| DIMM Presence | Echlon: |0123456789ABCDEF|0123456789ABCDEF|
| | |________________|________________|

Cell Compatibility: Complex - B, Partition - C; CPU Compatibility: C
PA System firmware rev 21.2
PDH controller firmware rev 15.6, time stamp: WED APR 21 14:15:30 2004

Front led`s of the Cell the led SMG is off;

Already replaces powerboard and cellboard, in tests the processors and memories is ok, swapped cell of the slot and nothing.

Please, Any suggestions ?

Thanks.
1 REPLY 1
U. Werner
Occasional Visitor

Re: SD32A Cell Error SMG LED is OFF

Hello Lucas!

There can be multiple reasons why the cell is not able to join a partition.

What you need to check is the selftest of the cell by watching the chassis codes!

I recommend to power off the cell, power it back on and check the FPL and SEL logs on the MP.

If you like attach the logs so that we can check on them.