- Community Home
- >
- Servers and Operating Systems
- >
- Integrity Servers
- >
- Software power off needed
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-03-2006 03:28 PM
тАО09-03-2006 03:28 PM
My machine is a cx2620. I need to turn off the system by command. Can any one help?
I think this can be done through the MP (Management processor..or something).
Regards
hiroshi
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-03-2006 04:54 PM
тАО09-03-2006 04:54 PM
SolutionYes can turn off the system from MP, below is the command.
MP: PC
PC : Remote Power Control - turn system power on and off
For proper system shutdown, shut down the OS before issuing this command.
This command allows the user to switch the system power ON or OFF, or Power
Cycle the machine. The user can have the action take place immediately, or
after a specified delay.
Note this is roughly equivalent to turning the system power off at the
front panel switch- there is no signal sent to the OS to bring the
software down before power is turned off. To turn the system off properly,
the operator must ensure that the OS is in the proper shutdown state
before issuing this command, by using the proper OS commands.
Best Regards,
Prashanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-03-2006 05:52 PM
тАО09-03-2006 05:52 PM
Re: Software power off needed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-05-2006 06:07 AM
тАО09-05-2006 06:07 AM
Re: Software power off needed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-05-2006 08:22 PM
тАО09-05-2006 08:22 PM
Re: Software power off needed
cm>pc
it will show the power status, and some on/off option. u will do it easily.
Cheers,
Awadhesh