Unable to see the booting information through telnet console on rx2660.

[sam_193]

Hi,

All I see is this,
Console is on a Serial Device

Booting kernel...



HP-UX will call firmware in physical-addressing mode



Memory Class Setup

-------------------------------------------------------------------------

Class Physmem Lockmem Swapmem

-------------------------------------------------------------------------

System : 2027 MB 2027 MB 2027 MB

Kernel : 2027 MB 2027 MB 2027 MB

User : 1133 MB 985 MB 989 MB



After this it doesnt show anything...

Appriciate your help on this??

Regards,
Sam

[Torsten.]

Did you adjust the console setting?

http://docs.hp.com/en/AB419-9005A/AB419-9005A.pdf

[L. Belli]

Boot into EFI shell

Then at the shell prompt type :

Shell> conconfig

It will shows current configuration for your console
Ex:
-- --- ------
1 P Serial
2 S VGA


Then to switch to VGA type (referring to my example - see your output to choose correctly):

Shell> conconfig 2 primary

This will tell the EFI to prone everything about the o.s. stdout to the VGA card.

Hope this helps,

Luigi

[Grayh]

Log on to MP and send the following info to analyse the issue...

MP>SL>E>D
MP>SL>F>D
MP>CM>PS
MP>CM>DF
MP>CM>SYSREV