Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

configuring MP LAN on rx 6600

 
mrmo07
Regular Advisor

configuring MP LAN on rx 6600

i am trying to configure MP LAN (i have configured IP by arp) but after that i can not configure subnet or gateway ( either console or lan port) its showing inconsistent parameter . i can not change IP, subnet or gateway. plzz help

Regards,
Morshed.
10 REPLIES 10
Steve Reece_3
Trusted Contributor

Re: configuring MP LAN on rx 6600

Hi Morshed,

The best way to configure the IP address, subnet and gateway on the rx6600 MP LAn is to connect up a serial line and use the LC subcommand in the command menu.
To login, use Admin as the username and Admin as the password.
If the gateway is not on the same subnet as the IP address of the MP then this will probably give you the kind of error that you are seeing. Make sure that the gateway and IP address are consistent with the subnet mask.

Steve
Bhadresh
Trusted Contributor

Re: configuring MP LAN on rx 6600

Hi Morshed,

There are various ways to configure MP LAN.
Configuring the iLO 2 MP LAN Using DHCP and DNS
Configuring the iLO 2 MP LAN Using ARP Ping
Configuring the iLO 2 MP LAN Using the Console Serial Port

Please have a look at the chapter 3 of â HP Integrity iLO 2 Operations Guideâ for detail:
The guide link is:

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01936251/c01936251.pdf


Regards,
Bhadresh

mrmo07
Regular Advisor

Re: configuring MP LAN on rx 6600

Hi,

actually i have tried with all the way (serial consol) LAN port etc. very firstly have assing temporary IP address by arp -s IP MAC command. it was working. now when i try to change IP subnet gateway its come with + sign and got message below + indicate inconsistent parameter.finally i cannot save the change. old configuration retains. i have also tried web based but same...plz help.
Torsten.
Acclaimed Contributor

Re: configuring MP LAN on rx 6600

Can you send a screenshot/screencapture of the

MP:CM> lc

command?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
mrmo07
Regular Advisor

Re: configuring MP LAN on rx 6600

Hi,
yes i can but i need to go client site. need little time. but i can clarify u one thing. normally when we press MP>CM>LC its show all parameter and below message should be


"Enter parameter(s) to revise, Y to confirm, or [Q] to Quit: Y"

but here i cant find Y to confirm instead i find A to modify all.

even i modify cant confirm ,i need to quit by pressing Q.

and retains old configuration.

Regards,
Morshed.