Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

hp ux- problem screen

 
taouw
Frequent Advisor

hp ux- problem screen

I have a server rx2600, but i have a problem to connect this server to the screen (i have a simple cursor), however i can connect to this server using the MP. can anyone help me, thank y.
6 REPLIES 6
R.K. #
Honored Contributor

Re: hp ux- problem screen

Hi Taouw,

How are you trying to connect to the server?

Try using putty and terminal setting as vt100 and see if it helps.

R.K.
Don't fix what ain't broke
Mel Burslan
Honored Contributor

Re: hp ux- problem screen

Your question does not make sense at all. What kind of screen you are talking about ? A Terminal ? If so, what is the model of this terminal ? How is it connected to Rx2600 box ? Serial cable ?

Simple cursor ?? Cursor is simple by definition. What else do you expect ? If you hit ctrl-b and see the MP menu, it means the terminal is working fine. What else are you expecting to see ?
________________________________
UNIX because I majored in cryptology...
taouw
Frequent Advisor

Re: hp ux- problem screen

I connect to a simple screen with a serial cable (VGA) not a console, the connection is working fine in MP, but the problem still exist in the terminal screen
Dennis Handly
Acclaimed Contributor

Re: hp ux- problem screen

>the problem still exist in the terminal screen

It would help if you mention the type of monitor, terminal or terminal emulator.
Matt Palmer_2
Respected Contributor

Re: hp ux- problem screen

If you can see output on the MP emulated screen then it may be that you have not correctly set the graphics mode in the EFI as there are 2 settings.
The way this normally manifests itself (For me) is that the initial start of the system where it does a hardware scan,etc is displayed, but right after "Launching /stand/vmunix..." you no longer see any output. Unless you change the VGA settings for the console in the EFI shell.

hope this helps

regards

Matt