Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx 6600 and LSI SAS Controller

 
Dusan Stefanovic
Frequent Advisor

rx 6600 and LSI SAS Controller

Hello Everyone

I install 2 rx 6600 with HP-UX on local disks.
I use LSI SAS controller with 2 disk in mirror configuration. When I create mirror one disk was primary and second one was secundary.
When I use sasmgr get_info... command everything looks fine. Both disk are ok (leds are also ok); but when i start management home page I see that one disk is degadrated (warning level). Situation is the same on both integrity servers.
Do you have any idea, maybe smh agent dont work with this cheap controller
3 REPLIES 3
Robert-Jan Goossens_1
Honored Contributor

Re: rx 6600 and LSI SAS Controller

Hi Dusan,

If you are running 11iV3, then have a look at this thread.

http://forums11.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=1291667

Regards,
Robert-Jan
Dusan Stefanovic
Frequent Advisor

Re: rx 6600 and LSI SAS Controller

Thanks

I have 11.31 and that is the problem.
I put patch Mart 2009 bundle but situation is the same. Obviously that did not fix that bug.
Dusan Stefanovic
Frequent Advisor

Re: rx 6600 and LSI SAS Controller

...