Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx2600 server console redisplay question

 
Trojan36
Frequent Advisor

rx2600 server console redisplay question

I have a rx2600 connected to a LCD via the VGA.
But server is telling me that the console is on a serial device and no further output will appear on this output device. I am guess that the console is being displayed in the serial connection on the three headed cable.

My question is how do I get the console to ve redirected to the VGA port. I tried play with the different output option in the boot up section but can't seem to find the right combination. Thx in advance.
2 REPLIES 2
Trojan36
Frequent Advisor

Re: rx2600 server console redisplay question

Thanks everyone, I solved the issue by deselecting all the entries, except for the last entry in the boot out menu. It force the display to go to VGA port.
Torsten.
Acclaimed Contributor

Re: rx2600 server console redisplay question

If you re-direct the console to VGA only, you have no remote access via the MP. Consider to use the graphics display as a X terminal only.

Try this:

Check /etc/dt/config/Xservers.
If last line is commented out as follows:

# * Local local@console /usr/bin/X11/X :0

remove '# ' and restart dtlogin:

# /sbin/init.d/dtlogin.rc stop
# /sbin/init.d/dtlogin.rc start

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!