HPE Community
Integrity Servers
1753863 Members
7252 Online
108809 Solutions
New Discussion

Re: rx2620 booting problem

 
munawar
Occasional Contributor

‎01-22-2008 11:43 PM

‎01-22-2008 11:43 PM

rx2620 booting problem

I have rx2620 server. I am using smart setup 4.8.4 for the Redhat AS 4.0 (Itainium) installation. All of my installation is completed smoothly. But on next boot it gives me an error "no controller found" and then after a long messeges on the screen an error appear "Kernal panic - not syncing: Fatal exception"

I am new to RX family. Please give me step by step instructions.

I have five partitions. Two are made by smart setup utility and the rest of three are" /" "swap" "/boot/efi"

thanks
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎01-23-2008 08:42 AM

‎01-23-2008 08:42 AM

Re: rx2620 booting problem

Sounds to me like a problem with the kernel or drivers.
I would ask the question in the linux sub-forum.

I would recommend to give a bit more info about the error itself (capture the output and attach).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.