Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx2620 - doesn't boot after changing status panel board

 
Milan Davidovic
Occasional Advisor

rx2620 - doesn't boot after changing status panel board

After changing status panel board system didn't boot Red Hat Linux (from internal drive - two 72 GB scsi disks). It resets itself and start the self test from begining. I tried to boot from DVD drive, but result was the same.
Sometimes system passed self-test and EFI shell appear, sometimes I had FW fault (system LED is blinking red and LED2 is red).
I tried to boot CD with new FW (ISO image), but with no success. I received the following SE events:

Log Entry 2: 08 Jun 2009 14:54:15
Alert Level 7: Fatal
Keyword: Type-02 076f03 487171
No events were received from system firmware
Logged by: Baseboard Management Controller;
Sensor: Processor
Data1: FRB2/Hang in POST failure
0x204A2D2617020030 FFFF036F00070300

I think that I have FW problem.
Any idea how to resolve this problem ?
4 REPLIES 4
Highlighted
TTr
Honored Contributor

Re: rx2620 - doesn't boot after changing status panel board

> Data1: FRB2/Hang in POST failure

It appears that there is a serious harware error that is detected by post. Ensure that the "status panel board" was installed correctly and no other components were left out or were disturbed in the process.
Milan Davidovic
Occasional Advisor

Re: rx2620 - doesn't boot after changing status panel board

I tried with old status panel board and received the following SE notification:

Log Entry 8: 09 Jun 2009 09:49:57
Alert Level 7: Fatal
Keyword: MC_INITIATED
Machine Check initiated
Logged by: System Firmware 0
Data: Major change in system state - HPMC or MCA
0xF480009800E000B0 000000000000000B


Log Entry 7: 09 Jun 2009 09:49:57
Alert Level 7: Fatal
Keyword: Type-02 137001 1273857
Machine Check initiated
Logged by: Redundant w/ an E0 code;
Sensor: Critical Interrupt
Data2: OEM Code2: 0x00
0xC14A2E30450200A0 003FA17000130300

It always happens when I try to connect any device (disk or dvd). System resets itself and starts self-test.
cnb
Honored Contributor

Re: rx2620 - doesn't boot after changing status panel board

Can you post your FRU and SYSREV info from the MP?

MP:CM> DF -all -view text
MP:CM> SYSREV



Milan Davidovic
Occasional Advisor

Re: rx2620 - doesn't boot after changing status panel board

I uppgraded system FW from V4.10 to V4.29, with telnet sesion to MP. It wasn't possible to upgrade with direct serial connection.
Now everything is OK.

Thanks.