cancel
Showing results for 
Search instead for 
Did you mean: 

rx2620

 
freddy-hq
Occasional Contributor

rx2620

Hi all,

I try to connect my rx2620 to null serial cable via hyper terminal. I have a connection and the boot sequence display on my hyperterminal how ever i can't use the keyboard to correspond.
Can anybody help.

Regards.
3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: rx2620

Hi,

you have to stop at the EFI boot menu and check the console device settings.

There is a device for input, another for output and a third for error output.

Make sure all are set to the same device.

Otherwise your output may go to the serial port, the input is expected from the USB.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
freddy-hq
Occasional Contributor

Re: rx2620

Thank you for corresponding,

I don't have acess to any thing else than my output display on the hyperterminal.
How do setup what you told me.

Tx
Highlighted
Torsten.
Acclaimed Contributor

Re: rx2620

OK, close this thread and continue here:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1093056

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!