HPE Community
Integrity Servers
1752815 Members
6137 Online
108789 Solutions
New Discussion юеВ

Re: rx4640 MP issue

 
ffalcone
Occasional Advisor

тАО08-23-2006 03:29 AM

тАО08-23-2006 03:29 AM

rx4640 MP issue

I do not get a link status on my MP while connected to a Cisco 3750 Gigastack switch. I have tried both Auto and 10/half on the switch port settings. However, when I connect directly to my laptop, the MP link light comes on and I am able to navigate the web interface.

Any help is appreciated.
0 Kudos
Reply
2 REPLIES 2
rick jones
Honored Contributor

тАО08-23-2006 01:11 PM

тАО08-23-2006 01:11 PM

Re: rx4640 MP issue

You asked about this in netnews yes? Might check my "is it a cross-over cable" hypothesis.
there is no rest for the wicked yet the virtuous have no pillows
0 Kudos
Reply
Alan_152
Honored Contributor

тАО08-24-2006 02:57 AM

тАО08-24-2006 02:57 AM

Re: rx4640 MP issue

nic - nic == link
nic - switch == no link

Most definitely, you are using a crossover cable instead of a straight-through one. In addition, your switch doesn't have autosensing capabilites and won't alter its port configuration to accomodate your choice of cable.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.