Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx5670 display problem

 
usiddiqi
Advisor

rx5670 display problem

I've installed HPUX 11iV2 on my rx5670.
After installation, when I reboot the server, its reboots OK, just before login, monitor screen goes blank and says "Signal out of range". I'm using VGA console.
With Serial CON,it stopped responding suring the boot process.
Is there anyways I disable the VGA port and install the HPUX from CON.

thanks
3 REPLIES 3
Ian Vaughan
Honored Contributor

Re: rx5670 display problem

Howdy,
Can you get into the setup of the monitor and drop it into "fail safe" mode? Failing that can you drop the reolution in the monitor setting to the lowest it will go to or find an older clunkier monitor?

HTH
Ian
Hope that helps - please click "Thumbs up" for Kudos if it does
## ---------------------------------------------------------------------------##
Which is the only cheese that is made backwards?
Edam!
Tweets: @2techie4me
usiddiqi
Advisor

Re: rx5670 display problem

I've tried that, attached old beatup CRT monitor, but same result.
btw, just for testing I've installed windows and it works fine.
usiddiqi
Advisor

Re: rx5670 display problem

Changed settings in EFI from VGA to vt100 on serial.