Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx8640 memory problem

 
MárcioAFM
Frequent Advisor

rx8640 memory problem

Hello,

I have a rx8640 with one Partition (Partition 0) that have 3 cell's. In this partition i have 3 vPars. There was a energy problem and the only two partitions boot the vPar3 doesn't go up because says that have no memory. I tried to assign with vaprmodify memory but the return is no memory available.
I have a problem in cell 2 (3 VRM's in fault), do you think that can cause the server not to see the memory?

Best Regards,

Marcio
6 REPLIES 6
Sameer_Nirmal
Honored Contributor

Re: rx8640 memory problem

It depends on the vpar3 setup and the status of cell 2 assuming vpar3 was setup using it.

What do you see in
# vparstatus
# vpartstatus -p vpar3 -v


Kishore Anand
Occasional Advisor

Re: rx8640 memory problem

Please provide the following: -

1. MP:CM> ps (For all entity)

2. The output of the script attached.

Torsten.
Acclaimed Contributor

Re: rx8640 memory problem

"I have a problem in cell 2 (3 VRM's in fault), do you think that can cause the server not to see the memory?"

Due to the problems with cell2 you may have disabled memory = less memory than needed.

Contact HP support to get the H/W problem solved.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: rx8640 memory problem

To get more status info run this:

# echo "sel dev all;info;wait;il"|cstm

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
MárcioAFM
Frequent Advisor

Re: rx8640 memory problem

Hello all,


Thank you for the help, i asked for a new cell and replacd all the VRM's. After this no problem... everything goes uo okay.


Thanks you

Márcio