rx8640 rebuild and reconfigure

[egartexas]

we have a rx8640, not sure how many cells it has and how it is configured but i need to clear all the existing configuration

all i see is one partition 0

is there any start from scratch doc that i could refer to clear all and create two partition and re-build the system.

--------------
Cabinet | 0 |
--------+----+
Slot |0123|
--------+----+
Part 0 |.*..|

Partitions available:

# Name
--- ----
0) Partition 0

[cnb]

Hi,

http://docs.hp.com/en/5991-1247B_ed2/ch05.html

and

http://www.docs.hp.com/en/AB297-9012A-en/index.html

Hope this helps.


Rgds,

[cnb]

Hmmm...

These didn't get attached:

http://docs.hp.com/en/5991-1247B_ed2/ch06s02.html

and


http://docs.hp.com/en/5991-1247B_ed2/ch06s05.html

Rgds,

[cnb]

That last link is the task list for performing the steps:

http://docs.hp.com/en/5991-1247B_ed2/ch06s02.html


Rgds,

[egartexas]

parcreate cannot be run from MP console right, so we need to create the Partition one and then install OE and then execute parcreate and create partition. right

[cnb · Accepted solution]

Yes, follow the task guideline and you should all set.

Rgds,

FYI if this was helpful:

http://forums13.itrc.hp.com/service/forums/helptips.do?#33

Thanks ;-)