Integrity Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

unable to map DVD drive in Vpar - SuperDome2

 
Fenny
Occasional Contributor

unable to map DVD drive in Vpar - SuperDome2

Hi All,

 

I have connected the DVD drive from OA and now i am trying to search it in EFI shell but unable to locate it. At EFI shell i can only see my boot disk from 3Par. I have tried mapping the DVD drive to another partition and it's working perfectly there.

 

I tried "reconnect -r", "reset", "poweroff" but nothing seems to be working.

 

Shell> map -r
Device mapping table
  blk0 :BlockDevice - Alias (null)
        PcieRoot(0x7A)/Pci(0x0,0x0)/Pci(0x0,0x0)/Pci(0x5,0x0)/Pci(0x0,0x0)/Fibre(0x21230002AC001302,0x4001000000000000)

 

Checked multiple forums everyone is suggesting the same commands which i already tried. Any help will be highly appreciated.

 

 

P.S. This thread has been moved from HP-UX > System Administration to Servers > Integrity. - HP Forum MOderator

2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: unable to map DVD drive in Vpar - SuperDome2

This is not enough. You also need to assign the ILO of one of the blades to the vPar.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Highlighted
Fenny
Occasional Contributor

Re: unable to map DVD drive in Vpar - SuperDome2

Hi,

 

iLO is already assigned to this vpar, without assigning iLO you don't get the virtual devices option.