using multilple raid on rx6600

[shabash]

i have 2 disk installed with raid 1 card

and 3 disks installed with raid 5 card p400.

Now the raid 1 disk is accessible and led blinks and os is installed on them but raid 5 disk are not shown neither in os by command ioscan -fn disk.

any one help?

[Robert-Jan Goossens]

Hi Shabash,

Could you post the firmware version of you p400?

# sautil

Also post your HPUX version and the your RX6600 firmware revision.

MP:CM> sysrev

Regards,
Robert-Jan

Ps.

http://www.docs.hp.com/en/J6369-90074/J6369-90074.pdf

http://www.docs.hp.com/en/SM_SA3/SA_Support_Matrix.htm

[Torsten.]

Inspect the "ioscan -fn" output for "ciss devices, e.g. /dev/ciss5

and run

# sautil /dev/ciss5

# saconfig /dev/ciss5

and post the results.

[shabash]

i have attached the output.
i can see the additional harddisk added with raid 5 card but unable to find the raid 1 disks.

Now question is how can i see the Raid 1 installed disks??

[shabash]

when i run ioscan command it only shows one raid p400 card.
Now how can i see the raid one card information in the system

system OS is hp-ux v3

firmware are updated according to document

[Torsten.]

There are no logical drives - only 3 unassigned physical drives.

[shabash]

The default disk attached with raid 1 has OS installed in it.
they are 2 in numbers.Now how can i access that specific P400 card of Raid1???
if there are no logical drive then the drives on which os is installed is configured as mirroring or wht else?
kindly help?

[Torsten.]

Please post an

# ioscan -fn

[shabash]

raid 5 is p400 controller.

the 2 disks are configured with card escsi_ctlr.Manage by sasmgr

So escsi is raid controller or wht else card??

[Torsten.]

Your boot disks are on the built-in SAS controller, there is no RAID on the P400.