Community
LAN Routing
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

2848 Multicast capabilities

 
SOLVED
Go to solution
Watkins18
Occasional Visitor

‎03-16-2018 06:02 AM

‎03-16-2018 06:02 AM

2848 Multicast capabilities

Looking for clarification on multicast/igmp capabilities on the older 2848 switches.  I see that I can enable igmp per vlan and I have ip routing enabled.  My understanding is that ip routing is very light on this model.  My desire is to have multicast go across vlans.  Is that possible on this model switch?  Seems that igmp only handles the vlan it is assigned to...

0 Kudos
Reply
2 REPLIES 2
Vince-Whirlwind
Honored Contributor

‎03-18-2018 09:54 PM

‎03-18-2018 09:54 PM

Solution

Re: 2848 Multicast capabilities

I had a quick look at the 2600/2800/4100/6100 "Advanced Traffic Management Guide" and it mentions IGMP but not PIM.

For the 3500/5400 there is a manual called "Multicast and Routing Guide" - it mentions that PIM only works if you have a routing protocol (eg RIP) enabled.

Seeing as the 2800 series doesn't support RIP, I am guessing it doesn't support PIM.

0 Kudos
Reply
Watkins18
Occasional Visitor

‎03-19-2018 05:21 AM

‎03-19-2018 05:21 AM

Re: 2848 Multicast capabilities

Thanks Vince!  Came to the same conclusion, but just wanted a second opinion.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.