HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

HP5500 : Jumbo frame on only one port

 
NicolasBosIT
Occasional Contributor

HP5500 : Jumbo frame on only one port

Hi, 

My customer has 2 HP 5500 stacked (192.168.1.*). 

They are connected to another lan as 192.168.0.* by a trunk.

He asks to me if it's possible to activate the jumbo frame functionnality on 2 ports only. These ports are connected on 2 servers in the same lan.

I readed that the jumbo is active on ALL ports of the switche when this functionnality is active.

Thanks for your support,

Nicolas

 

 

 

1 REPLY
Linkk
Frequent Advisor

Re: HP5500 : Jumbo frame on only one port

Hi,

you can disable jumboframes on a per-interface level with "undo jumboframe enable" in interface context.

You are correct, jumboframes are enabled by default. 

If you disable jumboframes on this interfaces, too big frames will be discarded and it might lead to packet loss, if done incorrectly.

Best regards,
Linkk