HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

OSPF - redistribute Connected vs router ospf area OSPF-AREA-ID range IP-ADDR/MASK-LENGTH

 
UselessUser1
Contributor

OSPF - redistribute Connected vs router ospf area OSPF-AREA-ID range IP-ADDR/MASK-LENGTH

Hi,

 

Coming from a CISCO world the configuration of OSPF is very different on HP ProCurve...

 

It appears most places seem to say that for all VLAN's on a device they need to be assigned to an OSPF area, then to actually get these to propogate to other switches you need to use the redistribute connected command on the OSPF process?

 

I was wondering therefore what the other command I have listed does instead of doing it like this?

1 REPLY
Rich R_1
Advisor

Re: OSPF - redistribute Connected vs router ospf area OSPF-AREA-ID range IP-ADDR/MASK-LENGTH

What I do is this:

 

Say you have vlan 200:

conf t

vlan 200 ip ospf area 0 (backbone)

vlan 200 ip ospf passive

 

I do not use redistributed connected, I just use passive for terminating networks on OSPF.