PPPoA on 3034

[thegrave]

Hello,



I have to play with some 3COM routers next week so I need some help. I have to bring up a back-to-back G.SHDSL connection up between two 3034s. The customer is going to use PPPoA for encapsulation so I tried to make a sample config before going into the lab. Please take a look and tell me if you see any obvious problems with it:



Router1



interface atm 1/0

activate

shdsl annex b

pvc 0/1

map ppp virtual-template 1



interface virtual-template 1

ip address 192.168.0.1 255.255.255.0



Router2



interface atm 1/0

activate

shdsl annex b

pvc 0/1

map ppp virtual-template 1



interface virtual-template 1

ip address 192.168.0.2 255.255.255.0



Has anyone done this? If so - does my config look OK? If not - can you suggest corrections or post a working config?



Thanks in advance!



Stefan

[thegrave]

Well, just tested it today, works perfectly. Just in case someone needs to do it - for back-to-back configuration one side has to be set as G.SHDSL CO to emulate DSLAM services. This is done with the gshdsl mode co command (not 100% sure about the syntax, it's not mentioned in the command reference)

This message was edited by thegrave on 4-28-09 @ 8:17 AM