LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

Routing On HP 1950 Switch

 
Highlighted
Occasional Contributor

Routing On HP 1950 Switch

Hi ALL,

Having an 1950-24G-2SFP+-2XGT-PoE and HP 1950-24G-2SFP+-2XGT want to configure these switches as L3 Switch.

Need to know if i give command "ip route 0.0.0.0 0.0.0.0 (destination subnet) is enough for these switches to function as L3 switch or also required some more commands to enable L3 function on it.

 

Any help will be highly appreciated

1 REPLY 1
Highlighted
Honored Contributor

Re: Routing On HP 1950 Switch

That's the last resort route?!

Generally instead to have IPv4 routing enabled on a web based managed switch like the HPE OfficeConnect 1950 series is mandatory to assign VLAN Interfaces partecipating to routing proper IP Addresses...once a VLAN Interface has its own IP Address it partecipates to IPv4 routing automatically (on some Switch - those ones that are engineered to be managed mainly by CLI - you have to explicitly execute a ip routing command to enable routing but...I think that on HPE OfficeConnect 1950 it is not the case).