HPE Community
LAN Routing
1753820 Members
9236 Online
108805 Solutions
New Discussion

Re: VLAN 1 routing

 
rob misz
Advisor

‎03-26-2014 06:44 AM

‎03-26-2014 06:44 AM

VLAN 1 routing

      Does HP have a best practice dealing with VLAN1 (default_VLAN) when setting up there switches? We have 3 locations connected together with GIG fiber. The switches at these locations are Procurve 5400 series. I noticed that VLAN 1 is configured with an IP address and has RIP enabled on each location. VLAN1 on these switches are also on the same subnet. When I check the routing table it shows all the destinations were learned though RIP via VLAN 1. Should I create a separate VLAN that handles the routing between the switches?

0 Kudos
1 REPLY 1
TamNP
Respected Contributor

‎06-05-2014 08:23 PM

‎06-05-2014 08:23 PM

Re: VLAN 1 routing

Hello,

You can configure inter Vlan for routing between the switches
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.