HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

VLAN interface does not respond ping hp1910

 
Ivans1910
Occasional Contributor

VLAN interface does not respond ping hp1910

hello, my problem is I can not access the VLAN interfaces.

The setup is as follows:

 

vlan interfaces
*1   10.1.1.1/24      up manual
20   10.1.20.1/24   up manual

 

Active route table

 

Destination IP Address Mask Protocol Preference Next Hop Interface

 

0.0.0.0       0.0.0.0 Static         60                           10.0.1.2 Vlan-interface1
127.0.0.0    255.0.0.0 Direct          0                     127.0.0.1 InLoopBack0
127.0.0.1    255.255.255.255 Direct   0      127.0.0.1 InLoopBack0
10.1.20.0    255.255.255.0 Direct   0           10.1.20.1 Vlan-interface20
10.1.20.1    255.255.255.255 Direct  0      127.0.0.1 InLoopBack0
10.1.1.0    255.255.255.0 Direct   0             10.1.1.1 Vlan-interface1
10.1.1.1    255.255.255.255 Direct   0        127.0.0.1 InLoopBack0

 

port configuration

 

GE1/0/10 20 Hybrid 1

 

on port 10 is connected a pc. the gateway to the pc is 10.1.20.1

 

this pc can not reach the interface vlna , neither can ping it.

 

the settings right? It can be used as the VLAN interface gateway ?

 

2 REPLIES
Carter456
Occasional Contributor

Re: VLAN interface does not respond ping hp1910

what's the full config of port 10?

 

If the device connected on it has an IP address in the correct range and correct subnet mask then no reason it shouldn't be able to ping the vlan interface unless the port settings are incorrect.

johnk3r
Respected Contributor

Re: VLAN interface does not respond ping hp1910

Configures the port 10 as the access VLAN 20

**************************************
ATP FLEXNETWORK V3 | ACSA