LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

no ip routing hp 2910

edp_ita
Occasional Visitor

no ip routing hp 2910

 

I have a procurve hp 2910

 

My configuration is this

; J9145A Configuration Editor; Created on release #W.14.49

hostname "amministrazione"
module 1 type J9145A
trunk 18,20 Trk1 LACP
ip default-gateway 192.168.0.107
ip routing
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-13,15-17,19,21-24,Trk1
   ip address 192.168.0.200 255.255.255.0
   no untagged 14
   exit
vlan 2
   name "Vlan2"
   untagged 14
   ip address 192.168.30.200 255.255.255.0
   exit
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-HDx sensitivity high
fault-finder duplex-mismatch-FDx sensitivity high
console baud-rate 9600
router rip
   exit
snmp-server community "public" unrestricted
spanning-tree Trk1 priority 4


amministrazione# show ip route

                                IP Route Entries

  Destination        Gateway         VLAN Type      Sub-Type   Metric     Dist.
  ------------------ --------------- ---- --------- ---------- ---------- -----
  127.0.0.0/8        reject               static                                   0          0
  127.0.0.1/32       lo0                  connected                         1          0
  192.168.0.0/24     DEFAULT_VLAN    1    connected    1          0
  192.168.30.0/24    Vlan2           2    connected                 1          0

but i'm not ping from inter-vlan

Thank's all

1 REPLY
cenk sasmaztin
Honored Contributor

Re: no ip routing hp 2910

check default gateway client

 

vlan 1 member pc default gateway address must be 192.168.0.200

vlan 2 member pc default gateway address must be 192.168.30.200

 

disable windows firewall each pc

end disable ip default-gateway command on switch with

no ip default-gateway 192.168.0.107 command

cenk