Can't succesfully mirror.

[TIMOTHY J. REGAN II]

Joe I would suggest that on this CX3?? array that you have a Flare code no later than level 26 and the HP-UX hosts are defined as "Clariion Open". If you have multiple fiber paths pointing to the LUNs; i.e. cross bus mirroring then set the failover type for these LUNs to active/active.

You must also turn off this bad block relocation as the array will handle this for you auto-magically. ;-)

I asked earlier if load balancing software if any was used that could also be coming into the picture or not.

Hope things stabilize soon.