BladeSystem Forums have moved here
To make BladeSystem information easier to find, we have moved the BladeSystem forums here, to Servers and Operating Systems.
Showing results for 
Search instead for 
Do you mean 

Domain number changed

Go to Solution
Valued Contributor

Domain number changed

Hello all,


I have an LVM version 2.1 volume group that was created months ago using the newer disk device file names, so when vg05 was created, disk53, disk58 and disk62 were all included.


Yesterday, we lost a fibre channel switch and had to replace it.  The network guys inadvertantly changed the high level domain number when reconfiguring the switch.  So, in hardware addresses that had been 0/5/1/ the number "10" became a "1", the new addresses are like 0/5/1/, etc...


Is there anything I need to do to vg05 in order for it to recognize those new hardware addresses?  I am more accustomed to lvm 1.0 where I would vgextend and have alternate paths, but I'm assuming that's all just going to work by itself now with lvm 2.1?


Thanks in advance,


Honored Contributor

Re: Domain number changed

It's not so much the LVM 2.1 VG that will take care of this as it is the new I/O stack on HP-UX 11.31.


With 11.31 the OS will see and detect disks that point to the same physical disk/LUN and act accordingly.


If you run an 'ioscan -m dsf' you can see a  map of the persistent DSF to the legacy DSF.  An 'ioscan -m lun' will show you a bit of a different view.


As long as you can still see the disks through the new switch you should be OK.



Valued Contributor

Re: Domain number changed

Thanks Patrick, those flavors of ioscan made it crystal clear.