HPE Community
Operating System - HP-UX
1753857 Members
7490 Online
108809 Solutions
New Discussion юеВ

Multi path

 
jafarsithik
New Member

тАО08-25-2011 10:21 AM

тАО08-25-2011 10:21 AM

Multi path

how to check the multi path is working fine

0 Kudos
Reply
2 REPLIES 2
aice
Senior Member

тАО08-25-2011 02:48 PM

тАО08-25-2011 02:48 PM

Re: Multi path

On 11iv3 you can display the lun path information for all luns with the command "scsimgr lun_map".  This will give you informaiton on the total paths available to a given lun and the state of each path.

0 Kudos
Reply
Robert_Jewell
Honored Contributor

тАО08-26-2011 08:58 AM

тАО08-26-2011 08:58 AM

Re: Multi path

You can also use sar to display metrics for controllers if you wish to check on load balancing:

 

   # sar -H 2 10    (for example)

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.