Simpler Navigation coming for Servers and Operating Systems
Coming soon: a much simpler Servers and Operating Systems section of the Community. We will combine many of the older boards, and you won't have to click through so many levels to get at the information you need. If you are looking for an older board and do not find it, check the consolidated boards, as the posts are still there.
LVM and VxVM
cancel
Showing results for 
Search instead for 
Did you mean: 

VxVM 3.5 will not recognise vpath devices

Shane Russell
Regular Advisor

VxVM 3.5 will not recognise vpath devices

Hi I have a 2-node VCS 3.5 cluster. The nodes are running HP-UX 11.11 and connected to an EMC DMX using PowerPath 5.0.1 for load-balancing & multipathing. I need to virtualise the DMX behind an IBM SVC to facilitate a migration. To do this I need to un-install PowerPath and install IBM SDD ... which I have done. IBM SDD creates the vpath pseudo devices fine but the vxdisk list reports all paths and not just the controlling device. Any advice? NOTES : I can't use VxVM DMP because the vxlibibmsvc.so library is not available for 3.5 regards Shane Russell

 

 

P.S. This thread has been moved from HP9000 to HP-UX > LVM and VxVM. - Hp Forum Moderator