HPE Community
Operating System - HP-UX
1753789 Members
7710 Online
108799 Solutions
New Discussion

Re: proactive polling

 
David A. deVries
Occasional Contributor

‎03-03-2011 07:39 AM

‎03-03-2011 07:39 AM

proactive polling

You can run the pvchange -p n /dev/dsk/c#t#d# command to turn proactive polling OFF after you add the disk to a volume group, but is there a way to turn it OFF prior to adding it to a volume group? We are getting trespasses on the Clarion frame until I turn it off.

Thanks
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎03-03-2011 10:14 AM

‎03-03-2011 10:14 AM

Re: proactive polling

Do you have an active/passive array?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.