Simpler Navigation coming for Servers and Operating Systems
Coming soon: a much simpler Servers and Operating Systems section of the Community. We will combine many of the older boards, and you won't have to click through so many levels to get at the information you need. If you are looking for an older board and do not find it, check the consolidated boards, as the posts are still there.
LVM and VxVM
cancel
Showing results for 
Search instead for 
Did you mean: 

volboot file missing in HP-UX having Vxvm installed

suvy12
Frequent Advisor

volboot file missing in HP-UX having Vxvm installed

Hi, 

we have a HP-UX 11iv3 server in which is running on vxvm(bootdg).

 

After reboot this server is showing volboot missing error.

 

System Console is on the Built-In Serial Interface
afinet_prelink: module installed
AF_INET socket/streams output daemon running, pid 46
Starting the STREAMS daemons-phase 1
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 2, minor is 0x1; start = 0, size = 16777216
Starting vxconfigd in boot mode (pre_init_rc).
NOTICE: VxVM vxdmp V-5-0-34 added disk array DISKS, datype = Disk

VxVM vxconfigd ERROR V-5-1-1589 enable failed: Volboot file not loaded
transactions are disabled.
VxVM vxconfigd FATAL ERROR V-5-1-946 Rootdg cannot be imported during boot
Error returned from vxconfigd -m boot, halting
ERROR: The configuration could not be locked. It may be in use by
another process.
Calling function e000000001835260 for Shutdown State 1 type 0x1

sync'ing disks (0 buffers to flush):
0 fcache pages still dirty
0 buffers not flushed
0 buffers still dirty
Calling function e0000000022d7530 for Shutdown State 5 type 0x1
Calling function e000000001acd030 for Shutdown State 5 type 0x1

Closing open logical volumes...
Done

 

 

I tried to boot in vxvm maintainance mode(hpux -vm) as well as single user mode but getting same error.

On internet found out that it can be created again using below command in recovery mode

# vx_emerg_start -m hostname

 but not able to find the steps how to do ?

 

2 REPLIES
Highlighted
Ajay Agarwal
Frequent Advisor

Re: volboot file missing in HP-UX having Vxvm installed

To restore a missing or corrupted /etc/vx/volboot file

  1. Boot the system into maintenance mode.
  2.  Run vxconfigd in disabled mode:

    vxconfigd -m disable

  3.  Reinitialize the volboot file:

    vxdctl init hostid 

    vxdctl add disk sda privoffset=2144

  4.  Reset vxconfigd in boot mode:

    vxconfigd -kr reset -m boot

  5.  Use the following command to confirm that VxVM is running:

    vxdisk list

    DEVICE TYPE DISK GROUP STATUS

    sda sliced rootdisk bootdg online

    sdb sliced rootmir bootdg online

    sdc sliced - - error

  6.  Reboot the system.
suvy12
Frequent Advisor

Re: volboot file missing in HP-UX having Vxvm installed

Thnx for the reply but my system even not able to boot in maintainance mode.

So i re-installed the server using ignite.