- Community Home
- >
- Networking
- >
- Wireless
- >
- M and MSM Series
- >
- 11n protection mode has been enabled/disabled
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
12-18-2011 12:23 PM
12-18-2011 12:23 PM
11n protection mode has been enabled/disabled
Hello,
We are having big problems with users constantly loosing connection to the wireless network (MSM710 with six MSM410 APs) I activated debug logging on the AP:s and see the following messages repeated over and over...
21:12:40 debug kernel SG0032SW49 11n protection mode has been disabled
21:12:30 debug kernel SG0032SW49 11n protection mode has been enabled due to the presence legacy access points
21:12:15 debug kernel SG0032SW49 11n protection mode has been disabled
21:11:53 debug kernel SG0032SW49 11n protection mode has been enabled due to the presence legacy access points
21:11:52 debug kernel SG0032SW49 11n protection mode has been disabled
Some APs switch between enabled/disabled every 15 second without stopping. Is that normal behaviour or is it indicating a problem? I have only looked at the log while no user is connected so I don't know yet if it is the same when users are connected.
Thanks in advance
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP