3CRWDR101A-75 firmware update

[Dogdaniel]

Dear friends,

                       yesterday I updated the firmware, but I can´t get access to the set up (config page).(thru 192.168.1.1)

I've done all steps required buy the instructions papers without any problems.

But at the time to configure the router again isn´t possible. The IP self assigned is 192.168.2.1 and this is only for recovering activities. All other usual IPs do not respond (e.g 192.168.1.1)

Reseted and pushed the reset button more than 5 sec. several times. Nothing!!

The LAN is working. All PC's connected by wire to the router are working in a net. (same net name used before the firmware update ) It shows that the reset step to the original configuration is not working.

How can I get access to the browser configuration page?

Do I need to update again the firmware thru the IP 192.168.2.1 ??

Any ideas?? It will be appreciated.

Bes Regards

Daniel

[Dogdaniel]

Dear friends,

                       yesterday I updated the firmware, but I can´t get access to the set up (config page).(thru 192.168.1.1)

I've done all steps required buy the instructions papers without any problems.

But at the time to configure the router again isn´t possible. The IP self assigned is 192.168.2.1 and this is only for recovering activities. All other usual IPs do not respond (e.g 192.168.1.1)

Reseted and pushed the reset button more than 5 sec. several times. Nothing!!

The LAN is working. All PC's connected by wire to the router are working in a net. (same net name used before the firmware update ) It shows that the reset step to the original configuration is not working.

How can I get access to the browser configuration page?

Do I need to update again the firmware thru the IP 192.168.2.1 ??

Any ideas?? It will be appreciated.

Bes Regards

Daniel

[Techno]

Have you managed to resolve this ?

If the reset button for5 seconds does not work, you have ground for an RMA.

Hope this helps.

The Tech Man Has Spoken....